24 02-2023 6095 00
As soon as the machine is powered on
for the rst time, a guided sequence is
displayed for preliminary settings (model,
language, name of the machine, …)
The hydraulic circuit will be lled later on
(installation).
The installation procedure varies according
to whether the water supply of the machine
is from the tank or from the network.
watEr supply from tHE NEtwork
-As soon as you power on the machine, the
network solenoid valve is automatically
opened until the air break is filled.
-Open a solenoid valve of the boiler to vent
the air in the boiler and in the hydraulic
circuit.
Please Note: If there is no water during
the installation cycle, the machine will
stop and wait for water.
If a considerable amount of air bubbles
hydraulic circuit by using the "manual
-
ing the hydraulic circuit, the machine
will rotate the brew unit to position it
properly; the following is displayed in
sequence:
-the software releases of the equipment
-the heat cycle status of boilers.
After completing the heat cycle, drinks are
available.
watEr supply from tHE taNk
-As soon as you power on the machine,
the self-supply pump is started for some
seconds.
-Access the programming mode and use
the boiler filling / emptying function of the
“System” menu.
-At the end of the installation cycle, reset
the “no water” failure.
SANITISING FOR THE FIRST TIME
As soon as you install the machine, care-
fully sanitise the mixers, the tubes intended
to dispense instant drinks and the tank (if
any) in order to guarantee the hygiene of
dispensed products.
It is absolutely forbidden to use water
Sanitise by making use of sanitising prod-
ucts.
Wash the mixers and add some drops of a
sanitising solution.
After having sanitised, rinse the mixers
abundantly to remove any residue of the
solution in use.
To dispense water in the mixers, use the
rinse function from the "wash" menu.
Important!
The machine is equipped with an au-
tomatic washing system for the mixers
with the relative hydraulic circuit and
the brew unit.
If the machine is not used for a long time
(week ends etc.), even for less than two
days, it is recommended to enable the
automatic washing functions (e.g. before
starting to use the VM)
To Next Page
Loading...
