EVOCA Opera Touch - Cashless System Settings

02-2023 6095 00 49
boilEr paramEtErs
To set up the operation parameters of the
boiler/s.
-Temperature: to set up the operation tem-
perature of the boiler
You can enable a heat cycle of the boiler
(boost) at the rst selection and after a
stand-by period
Enabling a heat cycle (boost) is of use to
balance a low temperature of the rst selec-
tion (after a stand-by period).
You can enable the boost even for all the
next coee-based selections.
For instant drinks, the heat cycle of the
boiler (boost) is for the rst selection only.
prE-DispENsiNg sEttiNgs
To enable and manage the heat and/or
rinse cycles before dispensing.
If these cycles are enabled, the time re-
quired to prepare drinks becomes longer.
mastEr slavE sEttiNgs
For the machine with Master / Slave con-
nection only
Use this function to enable the “Master /
Slave” connection.
If the function is active, the equipment is
“Master”: it controls the second machine.
The “Master / Slave” connection requires
the equipment to be connected with each
other by means of a special kit.
From the menu set up the model of the
“Slave” machine.
The master/slave function is not enabled by
default.
If the “Master / Slave” function is enabled,
you can use the functions relative to snack
and/or food products (e.g. arrangement of
snack selections).
The request for snack and/or food selec-
tions is made by the “Master” equipment.
Enable the “remote display” function to nav-
igate in the menus of the “slave” machine.
Use the conguration function for connect-
ing slave machines to display the software
version of the connected slave machine.
import / Export slavE sEttiNgs oN usb
To import and/or export the settings of the
connected "slave" machine on a USB key.