02-2023 6095 00 47
motor-DrivEN rEgulatioN of griNDiNg
wHEEls
If the grinding regulation is disabled or in
the equipment, where the regulation of
grinding wheels is motor-driven, you can
regulate grinding (coarser or ner).
Set up the value (expressed in 1/6 of a turn
of the grinding wheel ring nut) to bring the
grinding wheels closer or to move them
farther.
When grinding wheels are brought closer,
grinding is ner.
When grinding wheels are moved farther,
grinding is coarser.
Act manually on the regulation knob of the
grinder for the machines where the regula-
tion of grinding wheels is not motor-driven.
output sEttiNgs
EsprEsso uNit sEttiNgs
-No coffee: a sensor is intended to detect
the grinder rotation during grinding; in
case of a lock (e.g. foreign bodies) or if
the speed is too high (grinder empty), the
control will lock the selections using the
grinder;
-Pre-grinding: to enable / disable coffee
grinding for the next selection. Pre-grind-
ing decreases the time necessary to pre-
pare the next selection with ground coffee.
Pre-grinding compromises the flavour of
the next selection with ground coffee.
-To set up the position of the brewing
chamber of the brew unit.
Setting up the position of the brewing
chamber enables the coffee powder to
spread more homogeneously in the brew-
ing chamber.
-It enables the brew unit to re-position as
soon as the equipment is powered on.
If the brew unit is re-positioned, you can
be sure that it has reached its correct posi-
tion before dispensing.
-It enables the dose variation of the first
coffee (increase in the water dose of the
first coffee)
suctioN paramEtErs
To enable / disable the operation of the fan
wheels in the equipment.
vapour suctioN
-ON: the fan wheel is always active.
-OFF: the fan wheel becomes active during
the preparation of the drink.
ligHtiNg
To set up the lighting parameters of the
equipment.
You can set up:
-if the lighting of the equipment must re-
main on or off when the equipment is out
of order;
-decide whether to enable the lighting of
the dispensing compartment.
sEttiNgs of tHE cup DispENsEr
Use this function to determine:
-the delay time for stopping the rotation of
the cup stacker
-the time that must elapse from when the
cup release motor is activated till when the
cup is acknowledged by the cup sensor
Use these parameters to balance any iner-
tia due to the type of cup.
sEttiNgs of mobilE NozzlEs
Use this function to determine:
-the position of mobile nozzles to dispense
hot or cold water only.
The position of nozzles is expressed as a
percentage of the time nozzles require to
reach their dispensing position.
-set up after how long to move the nozzles
back to their stand-by position after a dis-
pensing cycle.
The delay time enables the tubes to get
empty and to drip in the cup.
The customised position of nozzles ena-
bles the operator to avoid any contamina-
tion of a water-only selection.
experimentation.
To Next Page
Loading...
