48 02-2023 6095 00
maiNtENaNcE
programmiNg automatic wasH / riNsE
cyclEs
You can enable / disable the programming
of automatic wash and/or rinse cycles of
the equipment.
Programme the type of wash and/or rinse
cycle to be performed on the day and at the
time you have set up.
You can add and remove automatic wash
and/or rinse cycles.
Automatic wash / rinse cycles use
hot water. Never put your hands in the
dispensing area: danger of burns.
Wash cycles are not intended to re-
place the necessity to disassemble the
components for sanitising purposes
regularly.
A message is displayed during wash / rinse
cycles to show the progress of the opera-
tion.
NExt maiNtENaNcE
Enable and set up the maintenance interval
and/or number of dispensing cycles.
As soon as one of the set up values is
reached, the equipment shows the mes-
sage “maintain”.
NoticE of maiNtENaNcE
To reset the counter managing the notices
of maintenance.
To manage notices properly, reset the
counter only after carrying out all main-
tenance operations.
mEssagEs for wasH cyclEs
Set up the intervals (number of hours and/
or selections) for each type of wash / rinse
cycle.
As soon as one of the set up values is
reached, the equipment shows a message
prompting the operator to wash / rinse.
Every single wash / rinse cycle may be
made compulsory: the equipment or some
functional units are put out of order until the
wash / rinse cycle is carried out.
NExt wasH cyclEs
It displays for each type of wash / rinse
cycle when a wash / rinse cycle must be
carried out.
gENEral sEttiNgs
powEr supply
To set up the power supply voltage used to
supply the equipment.
The set up enables the user to man-
age all electric components properly
and to optimise the operation cycles of
the equipment.
taNk
The machine can be supplied with water
from the network (OFF) or from a tank
(ON).
HyDraulic circuit
To set up the hydraulic circuit of the equip-
ment (standard or with double boiler).
-
sen is the one of the equipment
The set up enables the user to man-
age all electric components properly
and to optimise the heat cycles of the
boiler/s
accEss to mENus wHEN tHE Door is
closED
To enable the access to programming
menus when the door is closed.
To Next Page
Loading...
