EVOCA Opera Touch - Page 60

52 02-2023 6095 00
No watEr
Lack of water in the water network or self-
supply tank.
Make sure that the equipment is connected
with the water network and that the tap is
open or that the tank is full of water.
Touch the “Reset” key to restore the opera-
tion of the equipment.
No coffEE
If the ground dose is not reached in the
doser within 15 seconds, the "no coee"
failure is recorded.
The selections using coee beans are put
out of order.
griNDEr lock
A sensor detects the actual rotation of the
grinder during the grinding time.
In case of lock (foreign bodies, etc.), the
grinder is locked and espresso-based se-
lections are disabled.
macHiNE boarD
Lack of communication between the ma-
chine board and the CPU board.
The communication between the two
boards occurs through can bus.
Check the can bus connections between the
two boards.
low EsprEsso tEmpEraturE
The temperature of the espresso boiler is
lower than the minimum temperature pro-
grammed for a dispensing cycle.
Wait for the minimum temperature set up
for dispensing to be reached.
macHiNE DatabasE Not availablE
The machine database intended to group
and manage the machine congurations
(layout) is not available in the equipment or
it can’t be loaded or created.
Make sure that the memory space is
enough.
The equipment is put out of order.
statistics
sHow statistics
It displays the statistics relative to selec-
tions (e.g. the number of dispensing cycles
carried out, date and time of the last dis-
pensing cycle, …)
rEsEt statistics
It resets the statistics stored for selections.
sHow auDits
It displays the total number of dispensing
cycles and the total number of dispensing
cycles after the last statistics reset as well
as the amount collected for every single
selection.
The function enables the operator to lter
the display of audit data by category.
NumbEriNg of sElEctioNs
To number the selections and have a drink -
selection number match in the statistics.
 Every single selection must have a uni-
vocal number.
favouritEs
The favourites are links with the functions
frequently used.
After adding a function to your “favourites”,
you just have to display the “favourites” and
touch the function for rapid access.
list of favouritEs
It displays all the functions that are fre-
quently used and that have been stored as
“favourites”
Touch the function for access.
DElEtE list of favouritEs
To remove the functions that have been
stored as “favourites” .
You can remove one single function or all
functions (delete all).
To remove one single function: touch the
function key and conrm the removal from
the list.