EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
103
11.9.3.1 FILM FX
Selecting this function will create a film style effect during the playout of the
playlist by repeating one field every two fields. Please note that the audio is
also affected by this effect, making it unusable and therefore, muted. This
mode is deactivated when exiting a playlist.
11.9.3.2 NEXT
While the playlist is rolling on air, selecting the Next function will start the
transition of the next clip with the transition effect listed on the playlist. This
can be used if a clip is running too long and it is necessary to shorten up
the playing time.
11.9.3.3 SKIP
While the playlist is rolling, the next clip in the sequence is always
displayed on the PRV screen. The Skip function allows the operator to
discard clips before they go on-air. The clip that will be «skipped» is the one
displayed on the PRV screen. This function does not remove the clip from
the playlist, but it simply allows it to be skipped during playback.
11.9.3.4 EDIT
Selecting the Edit function gets the user back to the Playlist Edit mode.
11.10 GENERAL EDIT FUNCTIONS
AVAILABLE FOR PLAYLISTS
11.10.1 FUNCTIONS AVAILABLE ON THE LSM REMOTE IN
PLAYLIST EDIT MODE
In the Playlist Edit mode, as each clip is highlighted, the first frame can be
seen on the display monitor. To change any of the options, simply highlight
the desired clip, then select a function from the above menu and use the
control lever to adjust to the desired value.
In Playlist Edit mode, the duration displayed in the top right corner of the
LCD screen is the playlist total duration, from the beginning to the end
.
11.10.1.1 INSERT
The Insert function allows the operator to insert a clip into the playlist. The
same operation can be achieved using the TAKE key.
11.10.1.2 SPEED
The Speed function allows defining the speed at which one or all clips of
playlist will be played. Select the playback speed of the clip with the lever,
To Next Page
Loading...
Need help?
General
