EVS Multicam LSM Operating Manual

Issue
10.01.F
EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
22
5.4 SYNCHRONISATION MODE (SWITCH
TO IN)
If the synchronisation mode is OFF, a request for camera change will
produce a jump at the same timecode on the requested camera. This mode
allows synchronous change of camera angle.
If the synchronisation mode is ON, a request for a camera change (by
pressing CAM A, CAM B CAM C or CAM D in the Multicam menu) will lead to
a jump to a predefined CUE IN point.
If a CUE IN point has not been previously defined, Multicam acts as in SW to
IN OFF mode (even if SW to IN ON is shown) because the system has no
reference to jump to.
Cue In1
Clip B
Clip A
Clip C
Clip D
Cue In2
Cue In3
Cue In4
Cue In1
Cue In2
Cue In3
Cue In4

EVS Multicam LSM Specifications

General

Brand	EVS
Model	Multicam LSM
Category	Remote Control
Language	English