Issue
10.01.F
EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
90
If no playlist is loaded on the PGM1:
• The information displayed on the Playlist Screen refers to the current
playlist, except the remaining time, which is not displayed.
• The Play, Skip, Next and Recue commands and NOT displayed on the
blue-highlighted section at the bottom of the page.
11.4 ACTIVATING & LOADING A PLAYLIST
11.4.1 INTRODUCTION
A distinction is made between activating and loading a playlist:
• When you activate a playlist, you access the playlist location on the
server but you do not load it on a player channel. Once the playlist is
active, it is called the ‘current playlist’. You can insert clips directly in
the current playlist without having to load it onto a channel.
When Multicam is switched on, the active playlist is automatically the
Playlist 11, i.e. the playlist 1 on bank 10 of page 1.
• When you load a playlist, you actually load it on a given player channel
either to edit it or to play it out.
11.4.2 HOW TO ACTIVATE A LOCAL OR DISTANT PLAYLIST
You can activate a playlist via the Remote Panel or via the VGA screen.
11.4.2.1 VIA THE REMOTE PANEL
To activate a playlist via the Remote Panel, proceed as follows:
1. Do one of the following
2. To activate a local playlist, go directly to step 2.
3. To activate a distant playlist, press the SHIFT + Network keys and
select the F_ key corresponding to the server on which the playlist is
located.
4. Go to the requested page by pressing SHIFT + PAGE + the F_ key
corresponding to the requested page.
5. Go to the playlist bank of the page by pressing SHIFT + F10.
6. Select the playlist as required (press F1 - F10)
PAGE 1 contains Playlists 10 to 19, PAGE 2 contains 20 to 29, PAGE 3
contains 30 to 39, and so on.
7. Press ENTER on the Remote Panel to confirm.
To Next Page
Loading...
Need help?
General
