EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
135
12.5 EDITING OPERATIONS
The timeline editing operations on the remote require marking IN and OUT
points on the recorder before performing the extend or insert actions. These
IN and OUT points can be marked anywhere on the timeline as in the
Replace mode since the timeline is equivalent to a record train.
12.5.1 EXTEND OVERWRITE
The Extend feature in Multicam consists of extending the length of a timeline
element by extending the IN or OUT points of a clip as explained below, as
long as the material is available.
If the required material is not available, the Remote Panel will beep. The
Extend is always performed in Overwrite mode, which means that the
material ‘covered’ by the Extend is deleted from the timeline.
12.5.1.1 EXTEND FROM IN
This editing action shifts the OUT point of the timeline element which
includes the Mark IN to the defined Mark OUT. The following schema shows
an example with only the video track selected.
12.5.1.2 EXTEND FROM OUT
This editing action shifts the IN point of the timeline element which includes
the Mark OUT to the defined Mark IN. The following schema shows an
example with only the video track selected.
To Next Page
Loading...
Need help?
General
