Issue
10.01.F
EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
118
4. Press to highlight V DELAY (SHIFT + B)
5. At the on screen prompt, enter a value on the F_ keys including leading
zeros (0+2+1+2= 2:12), OR move the lever and press ENTER.
The value entered will be present on the PRV SCREEN when the clip is next
to play in a playlist.
Edit point (A BASE)
Video from the previous clip is extended and video from the clip being edited
is shortened.
Note
When editing using the Video IN/OUT as the reference point (V
BASE) the video will be the top line on the OSD display. When
editing using the audio IN/OUT as the reference point (A BASE)
the audio will be the top line on the OSD display.
11.12.9.3 V
IDEO
S
PLIT
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press to highlight A Base (SHIFT+B)
4. Press to highlight V SPLIT (D)
5. Jog to the point where you want to set your transition
6. Do one of the following:
o Mark an OUT point if you do a video delay.
o Mark an IN point if you do a video advance.
The value entered will be present on the PRV SCREEN when the clip is next
to play in a playlist.
11.12.9.4 ‘IN’
K
EY
C
OLOURS IN
P
LAYLIST
M
ODE
When the Playlist is sitting on the Video and Audio IN point of a Clip, the IN
key will light RED.
When the Playlist is sitting on the Video IN point of a Clip, the IN key will
also light RED.
When the Playlist is sitting on the Audio IN point of a Clip, the IN key will
FLASH RED.
If the Playlist is in a position where the Audio and Video are synchronous,
the IN/OUT keys will be GREEN.
To Next Page
Loading...
