EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
59
3. If you want to modify the LTC time code and date, type in the new
time code for the Short IN point and date of the clip in the Set TC
field below the LTC field.
4. If you want to modify the user-defined time code and date, type in the
new time code for the Short IN point and date of the clip in the Set TC
field below the USER field.
5. If you want to modify the primary TC for this clip, press the A or B key
which corresponds to the requested primary TC.
6. Press F2 to select CAM or CLIP mode
• In CAM mode, only the time code of the camera angle loaded on
the primary channel will be changed.
• In CLIP mode, the time code of all camera angles of the clip will
be changed.
7. Press ENTER to confirm or ESC to cancel.
The entire clip is updated according to the new time code value so that the
time code remains continuous inside the whole clip.
Note
In 59.94Hz modes (NTSC), you can also select between DROP
FRAME and NON DROP FRAME modes by pressing the space bar.
To Next Page
Loading...
