DTP CrossPoint 4K Series Matrix Switchers • Matrix Software 130
DSP Configurator View menu
Audio & Video I/O — Selects the audio and video I/O page for
the DSP Configurator program (the default view).
Audio I/O — Selects the audio-only I/O page for the DSP
Configurator program.
Video I/O — Selects the video-only I/O page for the DSP
Configurator program.
Meter Bridge — Opens a Meters dialog box (see figure 72) with real-time meters that
monitor the audio levels at each input and output.
NOTES:
• Meter Bridge is available in Live mode and connected via the LAN port only.
• Figure 72 shows the 10x8 matrix size. Other models have 8 inputs and either 6, 4,
or 2 outputs.
Figure 72. Meter Dialog Box
Re-enable all dialogs — Re-enables all dialog boxes, the pop-up windows that allow
you to make changes to the parameters of a block.
Group Controls — Opens the Group Controls dialog box (see Viewing and using a
group master on page 122).
DSP Configurator Tools menu
Presets — Allows you to mark all items, save a preset, and
clear marked items:
• Mark All Ties — Mark (select) all created ties to save as a
preset.
• Mark All Items — Mark (select) all parts of the current
configuration, including processors, created ties, and mic
mixes to save as a preset.
• Save Preset — Save the currently marked processors, ties,
and mic mixes as a preset.
• Clear Marked Items — Unmark (deselect) all parts of the current configuration
(excluding presets), including processors, created ties, and mic mixes.
Connect to Device or Disconnect from Device (depending on Emulate or Live
mode) — Performs the same functions as the Mode Emulate and Mode Live buttons.
Device Manager — Opens the Device Manager dialog box, in which you can switch
between devices that use the DSP Configurator and also add, clone (duplicate), or delete
devices that use the DSP Configurator.
Issue RESET Command — Initializes and clears any or all of the following: ties, mic mixes,
presets, audio configuration, processor blocks, and gain blocks. This reset is identical to the
EZXXX} SIS command (see the System Reset SIS command page 76).
To Next Page
Loading...
