DTP CrossPoint 84 Series Matrix Switchers • Matrix Software 116
Highlighting and marking items, cutting or copying, saving a preset
When an item within the program is selected, it is green highlighted. One or more
highlighted items can be cut, copied, pasted, or saved as a preset. The cut, copy, and
paste functions can be performed using the task bar menus (see <Alt> key on the previous
page) or the shortcuts described on the previous page.
NOTE: When an item is cut, it is not removed from its original location until it has been
pasted in its new location.
Highlight multiple elements for cut, copy, paste, or a preset as follows:
1.
Use arr
ows (
, , , and ) to move to the first block to highlight.
2. To highlight sequential blocks:, press and hold <Shift> , then use arrows
( , , , and ) to navigate to and highlight additional elements.
When you reach the last element you want highlighted, release <Shift>.
3. To highlight non-sequential blocks:
a. Press and hold <Ctrl>, then use arrows ( , , , and ) to navigate to the
next desired element
b. Release <Ctrl>.
c. To highlight sequential blocks, press and hold <Shift>, then use arrows ( ,
, , and ) to navigate to and highlight additional elements.
d. To move away from the highlighted block or set of sequential blocks, press
and hold <Shift>, then use arrows ( , , , or ) to move the highlighting box
away from the last-highlighted element.
NOTE: If you do not perform step 3c, the last selected element will not remain
highlighted.
e. Release <Shift>.
4. To highlight another element or group of elements, repeat steps 1 through 3.
5.
T
o cut or copy, press the <Ctrl>-<X> or <Ctrl>-<C> combination.
6. To save a preset, press <Alt>, then <T>, then right arrow
, then down arrow
,
then <Enter>
(see figure63 on the next page)
.
To Next Page
Loading...
