Extron electronics DTP CrossPoint 84 - Rear Panel Operations

DTP CrossPoint 84 Series Matrix Switchers • Operation 37
4. Recall the preset: Press and release the Enter button. The configuration stored in
the selected memory location is now the current configuration and can be viewed in the
View-only mode (see example 4 on page34).
C O N T R O L
PRESET ENTER
ESCVIEW
1
2
3
4
OUTPUTS
The Enter and Preset
buttons return to unlit or
background illumination.
Press the button.
All input and output buttons return
to unlit or background illumination.
Muting and Unmuting Video and HDMI Audio Outputs
Individual outputs can be muted or unmuted as follows:
NOTES:
•
Output mutes ar
e protected when front panel Lock mode 2 is selected. You can
view the status of the output (muted or unmuted) in Lock mode 2 but you cannot
change it from the front panel (see Setting the Front Panel Locks (Executive
Modes) on page43).
•
Audio mute silences the HDMI audio and S/PDIF audio only
, not the analog or
amplified audio.
1.
Pr
ess the Esc button to clear any input button indications, output button indications, or
control button indications that may be lit.
2.
Pr
ess and release the View button.
3.
Pr
ess the Video button and the Audio button to select video, HDMI audio, or both to
mute or unmute.
4.
One at a time, pr
ess and hold the buttons for the desired outputs for approximately
2 seconds. The output buttons for the selected outputs blink to indicate the mute or
return to their previous state to indicate the unmute.
5.
Pr
ess and release the View button to return to normal switcher operation.
NOTES:
• You can mute video and HDMI audio, video-only, or HDMI audio-only outputs.
Pressing and releasing the Video button and the Audio button toggles each
selection on and off.
• When you enter View-only mode, the output LEDs turn on for all outputs
without ties.
• Mutes are saved to volatile memory. When power is removed and restored, all
outputs are unmuted.