DTP CrossPoint 84 Series Matrix Switchers • Matrix Software 75
Figure 37. Product Configuration Software (DTP CrossPoint 84 Shown Connected)
Menu
• Save — Saves a configuration file consisting
of a complete set of matrix switcher settings,
including ties, presets, EDIDs, input video
configurations, input audio configurations,
output video configurations, output audio
configurations, RS-232 insertion setting, and
screen saver settings, to a file. If no file
currently exists, the program prompts you
for a file name. The file extension for these files
is .extc.
• Save As ... — Saves a configuration file to a new location.
• Connect and Apply — Calls the Device Discovery screen where you can select
a different or the same Extron device, connect to it, and open and apply a saved
configuration file to it.
NOTE: Connect and Apply is unavailable for selection when the Product
Configuration Software is currently connected to a device.
• Open and Apply — Opens a saved configuration file and applies its settings to the
connected device shown on the currently selected device tab.
• Disconnect — Disconnects the Product Configuration Software from the unit while
leaving the program active.
33
To Next Page
Loading...
