Extron electronics DTP CrossPoint 84 - Use DHCP Check Box; Update the Firmware

DTP CrossPoint 84 Series Matrix Switchers • HTML Operation 134
Edit any of these changeable fields as follows:
NOTE: The address fields cannot be edited when DHCP is selected.
1.
Click in the desir
ed field. The graphic cursor becomes a text cursor.
2.
Edit the addr
ess or name as desired.
3.
Pr
ess the <Tab> key on the keyboard or click in another field to exit the field.
4.
Click the
Apply button (see figure78,
7
on page121) to make the address change
take affect.
Use DHCP Check box
The Use DHCP check box (
6
) directs the matrix switcher to ignore any entered IP addresses
and to obtain its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if
the network is DHCP capable). Contact the local system administrator to determine if this
is the appropriate selection. Click the Apply button (
7
) to make check box changes take
affect.
Update the Firmware
Click the Update button in the Device Info panel (see figure79) to open the Firmware
Update dialog box. The dialog box provides a way to replace the firmware that is coded in
the switcher without removing it from the system.
11
1111
1111
1111
1111
22
2222
2222
2222
2222
Figure 79. Firmware Update Dialog Box
Update the switcher firmware as follows:
1. Perform steps 1 through 6 of Installing the Software on page71, to download the
firmware upgrade from the Extron website.
2. Connect the PC to the matrix switcher via any switcher LAN port.
3.
Access the matrix switcher using HTML pages.
4. Click
Update in the Device Info panel (see figure79,
1
). The Firmware Upgrade dialog
box opens.
5. Click Browse (
2
). The Open dialog box opens (see figure80 on page135).
75