Extron electronics DTP CrossPoint 84 - Control Connections

DTP CrossPoint 84 Series Matrix Switchers • Installation 15
Control Connections
Tx Rx RTS CTS GTxRxG Tx Rx G
LAN 2
LAN 1
LAN 3
R
CONTROL
1234G
DIGITAL I/OCOM 3COM 2COM 1
SSGG
1
1
2
2
C34C
-S G+S+V
PWR OUT = 6W
IR/SERIALeBUSRELAYS
Tx Rx G
REMOTE LAN
Figure 7. Control Connections
NOTE: Figure 7 shows features of all models. Actual models can have either a LAN
port (item
Q
, below) or a control processor (item
R
), but not both.
Q
LAN port (non-IPCP model, see figure2 on page11) — If desired, for IP
LAN
control of the switcher, connect the matrix switcher to a PC or to an Ethernet
LAN via this RJ-45 connector. See TP connectors on page17 to wire the
connector. You can use a PC to control the networked switcher from anywhere
in the world using any of the following methods:
• SIS commands (see Using the Command and Response Tables on page55)
• The Extron Product Configuration Software (see Product Configuration Software
on page74)
• The DSP Configurator program (see DSP Configurator Program on page79)
•
Built-in HTML pages (see
HTML Operation on page130)
Act (yellow) LED — The Act LED indicates transmission of data packets on the RJ-45
connector. This LED should blink as the switcher communicates.
Link (green) LED — The Link LED indicates that the switcher is properly connected to
an Ethernet LAN. This LED should light steadily.
R
IPCP Pro 350 control processor (IPCP models only) —The IPCP models include
a built-in IPCP control processor that can control and monitor a variety of external
devices. The IPCP offers RS-232 and IR-based control, relays, and digital I/O controls.
Controllable devices can include:
• Projectors or other displays • Switchers • Projector lifts
• Source devices • Lights • Screen motors
See the IPCP Pro 350 Series User Guide at www.extron.com to make
all connections and to configure and operate the IPCP control processor.
Tx Rx G
REMOTE
S
Remote Port — Plug a serial RS-232 device into the matrix switcher via this
3.5 mm, 3-pole captive screw connector for remote control of the switcher
(see Serial and IR port connectors on page20 to wire the connector).
Switcher Reset
T
Switcher Reset button and LED — The Reset button initiates four levels of
RESET
reset of the matrix switcher. For the different reset levels, press and hold the
button while the switcher is running or while you power up the switcher (see
Rear Panel Operations on page45).
Power
U
Power connector — Plug a standard IEC power cord into this connector
50-60 Hz
100-240V ~
2.0 A MAX
to connect the switcher to a 100 VAC to 240 VAC, 50-60 Hz power source.
7
LAN port
IPCP Pro 350 processor
Remote Port
Switcher Reset button and LED
Power connector