Extron electronics DTP CrossPoint 84 - Operation; Front Panel Controls and Indicators

DTP CrossPoint 84 Series Matrix Switchers • Operation 22
Operation
This section describes the front panel operation of the DTP CrossPoint Matrix Switcher,
including:
• Front Panel Controls and Indicators
• Front Panel Operations
• Rear Panel Operations
• Troubleshooting
• Configuration Worksheets
Front Panel Controls and Indicators
The front panel controls (see figure17) are grouped into four sets. The Input buttons and
Output buttons,
A
and
B
, are grouped on the left side of the control panel. The control
buttons and video and audio (I/O) selection buttons,
C
through
H
, are grouped in the
center of the panel. The Volume controls (
I
and
J
) and the IPCP indications
(IPCP models only,
K
) are on the right side of the panel.
DTP CROSSPOINT 84 SERIES
DIGITAL PRESENTAT ION MATRIX
Extron
1
2
3
4
1
2
3
4
5
6
7
8
CONFIG
VOLUME
INPUTS
CONTROL
MIC VOLUME
I/O
OUTPUTS
AUDIOVIDEO
ENTER PRESET
VIEW
ESC
RTS
CTS
Tx
Rx
OVER
LIMIT
S
1
2 3 2
1
3 4
12
3
1
4
2
eBUS
COM
IR/S I/O
RELAYS
CC GG HHDD EE FF II JJ
AA
BB
KK
Figure 17. Front Panel, DTP CrossPoint 84 Switcher
A
Input buttons
B
Output buttons
C
Enter button
D
Preset button
E
View Button
F
Esc button
G
Video button
H
Audio button
I
Mic Volume (gain) knob and LEDs
J
Volume knob and LEDs
K
IPCP LEDs (control processor)
The illuminated buttons can be labeled with text, graphics, or both. The buttons
can be set to provide amber background illumination all the time, or the background
illumination can be turned off (see Background Illumination on page 43). The buttons
blink or are lit at full intensity (depending on the operation) when selected.
17