Extron electronics DTP CrossPoint 84 - Mounting Instructions; Removing and Installing Button Labels; Making Labels Using the Button-Label Generator Program

DTP CrossPoint 84 Series Matrix Switchers • Reference Information 147
Mounting Instructions
If desired, rack mount the switcher as follows:
1. Insert the unit into the rack, aligning the mounting bracket holes with those in the rack
(see figure 84).
Figure 84. Installing the Switcher in a Rack
2. Secure the switcher to the rack using the supplied bolts.
Removing and Installing Button Labels
Making Labels Using the Button-Label Generator Program
The Button Label Generator software creates labels that you can place in the translucent
covers of the input and output selection buttons. You can create labels with names,
alphanumeric characters, or even color bitmaps for easy and intuitive input and output
selection (see Installing Labels in the Buttons on page150 for the procedure for
removing and replacing the translucent covers).
Installing the Button Label Generator software
The Extron Button Label Generator is available on the Extron website. Install it as follows:
1. Go to www.extron.com and click the Download tab (see figure 85,
1
).
22
2222
2222
2222
2222
11
1111
1111
1111
1111
Figure 85. Location of Software on the Website
80