Extron electronics DTP CrossPoint 84 - DSP Configurator Program; Starting the Program

DTP CrossPoint 84 Series Matrix Switchers • Matrix Software 79
11. Click Update to continue (
4
).
The Firmware Loader utility tests the
connection, installs the update, and then
verifies the firmware.
At the conclusion of the process, the utility reports Upload Complete.
12. Click Close. The Product Configuration Software window returns to the front.
13. Click the in the connection tab to completely disconnect the program from the unit
and then reconnect the program as described in Starting the Program starting on
page74.
DSP Configurator Program
The DSP Configurator can connect to the switcher via any rear panel LAN port or the front
panel Configuration port. Use of the rear panel Remote (RS-232) port is not recommended.
Starting the Program
NOTE: Extron recommends connection via an Ethernet LAN port for the
DSP Configurator program.
Start the DSP Configurator Program by clicking the desktop icon or as follows:
1. Click Start > All Programs > Extron Electronics > DSP Configurator > DSP
Configurator. The DSP Configurator startup screen displays (see figure3640).
11
1111
1111
1111
1111
Figure 40. DSP Configurator Screen and DTP CrossPoint Selection
2. If necessary, select the DTP CrossPoint switcher in the drop-down box and click OK
(see figure 40,
1
).
TIP: If you have only DTP CrossPoint switchers of the same model, click Always
perform the selected operation to eliminate step 2 in future startups.
The DSP Configurator program starts in Emulate mode (see figure41 on page80).
36