Extron electronics DTP CrossPoint 84 - Installation; Setup and Installation Checklist

DTP CrossPoint 84 Series Matrix Switchers • Installation 10
Installation
• Setup and Installation Checklist
• Rear Panel Cabling and Features
• Front Panel Configuration Port
Setup and Installation Checklist
Preparation
 Familiarize yourself with the DTP CrossPoint matrix switcher.
 Obtain IP setting information for the matrix switcher from the local network administrator
(see the IPCP Pro 350 Series User Guide at www.extron.com).
Physical installation
 If desired, install the switcher in a rack (see Mounting the Switcher on page146).
 Cable input and output devices (see Video and TP Input and Output Connections
and Switches on page12).
 If desired, connect computers or control systems to any of the remote control ports (a
serial port [see Remote Port on page15], a USB port [see HDMI Inputs 1 through
6 on page12], and a LAN port [see IPCP Pro 350 processor on page15]) on the
switcher.
 Connect power (see Power connector on page15).
 Test the switcher by creating a tie (see Example 1: Create a set of video and audio
ties on page30).
 If desired, create and replace button labels (see Removing and Installing Button
Labels on page147).
Ancillary operations
 Install the Product Configuration Software and DSP Configurator software (see Matrix
Software on page70).