DTP CrossPoint 84 Series Matrix Switchers • Introduction 9
Remote power — Provides +5 VDC, 250 mA power on each HDMI output for powering
external peripheral devices, such as the Extron DVI 104. Power provided via an HDMI
output eliminates the need of a separate power supply for the connected peripheral device.
Front panel security lockout — Prevents unauthorized use in non-secure environments.
In lockout mode, a special button combination is required to operate the matrix switcher
from the front panel controller.
Ethernet monitoring and control — Enables control and proactive monitoring over a
LAN, WAN, or the Internet. An intuitive Web interface is included for configuration of the unit.
Built-in web pages — Enables the use of a standard browser for device monitoring and
configuration over an intuitive web interface.
RS-232 control port — Enables the use of serial commands for integration into a control
system. Extron products use the SIS - Simple Instruction Set command protocol, a set of
basic ASCII commands that allow for quick and easy programming.
Front panel USB configuration port — Enables easy configuration without having to
access the rear panel.
RJ-45 signal and link LED indicators for DTP ports — Provides a means for validating
signal flow and operation, allowing quick identification of connectivity issues.
Easy setup and commissioning with the Extron Product Configuration Software
(PCS) — Conveniently configure multiple products using a single software application.
Rack-mountable 2U, full rack width metal enclosure
Includes LockIt HDMI cable lacing brackets
Internal universal power supply — The 100-240 VAC, 50/60 Hz, international power
supply provides worldwide power compatibility.
To Next Page
Loading...
