Extron electronics DTP CrossPoint 84 - Establishing a connection

DTP CrossPoint 84 Series Matrix Switchers • Operation 44
Selecting Lock mode 2 or toggling between mode 2 and mode 1
NOTE: If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
If the switcher is in Lock mode 2, this procedure selects mode 1.
Toggle the lock on and off by pressing and holding the Video button and the Audio button
simultaneously for approximately 2 seconds (see figure25).
Lock mode 1
Lock mode 0
I/O
AUDIOVIDEO
I/O
AUDIOVIDEO
CONTROL I/O
AUDIOVIDEO
ENTERPRESET
VIEW
ESC
I/O
AUDIOVIDEO
Press and hold for
2 seconds.
Press and hold for
2 seconds.
Figure 25. Toggle Front Panel Lock Between Mode 2 and Mode 1
Performing a System Reset from the Front Panel
The front panel reset is identical to issuing the EZXXX} SIS command defined on
page 64. A system reset performs the following functions:
NOTES:
• System reset does not reset the Internet protocol (IP) settings or replace
user-installed firmware.
• This function resets not only the switcher, but any connected endpoints.
• Clears all ties and presets
• Clears all mutes
• Disables all RS-232 output inserts
• Restores group masters 1 and 2 to their factory defaults (Mic volume and Volume)
Reset the switcher to the factory default settings by pressing and holding the View button
and Esc button simultaneously while you apply AC power to the switcher (see figure26).
CONTROL
VIEW
ESC
Press and hold the buttons
simultaneously while you
apply power to the switcher.
Release the buttons.
Power
The switcher flashes
the button indicators
and then turns them off.
Continue to hold the View and Esc
buttons until all input and output buttons
return to unlit and the Video and Audio
buttons light.
Figure 26. System Reset
NOTE: If background illumination was turned on before the reset, the I/O and control
buttons are unlit after the reset. When you cycle power, background illumination
returns to the condition that you previously selected.
25
26