Extron electronics DTP CrossPoint 84 - Download the Startup Page and View Switcher Status

DTP CrossPoint 84 Series Matrix Switchers • HTML Operation 131
Download the Startup Page and View Switcher Status
Access the switcher using HTML pages as follows:
1. Start the Web browser program.
2. Click in the Address field of the browser and highlight any existing text.
3. Enter the IP address of the switcher in the Address field of the browser.
NOTE: If the local system administrators have not changed the value, the
factory-specified default, 192.168.254.254, is the correct value for this field.
4. Press <Enter>. The switcher checks to see if it is password protected.
NOTE: The factory configured passwords for all accounts on this device have been
set to the device serial number. Passwords are case sensitive. If the device is reset,
the password will be the original password configuration.
If the switcher is not password protected, it downloads the HTML page (see
figure71 on page121).
If the switcher is password protected, the switcher downloads the Authentication
Required dialog box (see figure76).
Figure 76. Authentication Required Dialog Box
NOTE: By default, the User Name is either admin or user, depending on the level of
authentication requested.
5. Click in the User Name field and type in the appropriate name.
6. Click in the Password field and type in the appropriate administrator or user password.
Click the OK button.
The switcher downloads the factory-installed HTML page (see figure77 on page132).
72