Extron electronics DTP CrossPoint 84 - Reference Information; Mounting the Switcher

DTP CrossPoint 84 Series Matrix Switchers • DSP SIS Commands 138
DSP SIS Commands
Command and Response Table for DSP SIS Commands
Many DSP functions; such as gain (which includes the mix-points), trim, mutes, and some
group master functions; can be controlled using SIS commands. These commands follow
the same general rules as basic SIS commands, but the variables (
X/s) tend to be more
complex. Also, a comprehensive understanding of the audio signal flow of the DSP is
helpful to understanding these commands. Thumbnails of the controls are provided in the
tables that follow for reference; the signal flow is described in detail in DSP Configurator
Program starting on page70. The
letters in the tables on on pages 144 through 148
refer to blocks of controls in the full DSP Configurator program window (see figure40 on
page80).
Line Input Gain Blocks (see figure40,
A
on page80)
Input Gain Trim Input Gain Trim
INPUTS 1 Input 5
Left
30000 30100
Left
30008 30108
Right
30001 30101
Right
30009 30109
INPUTS 2 Input 6
Left
30002 30102
Left
30010 30110
Right
30003 30103
Right
30011 30111
INPUTS 3 Input 7
Left
30004 30104
Left
30012 30112
Right
30005 30105
Right
30013 30113
INPUTS 4 Input 8
Left
30006 30106
Left
30014 30114
Right
30007 30107
Right
30015 30115
Mic Input Gain Blocks (
B
)
Input Pre-
mixer
Input Input Gain Pre-mixer
Gain
Input Input Gain Pre-mixer
Gain
INPUTS 1
40000 40100
INPUTS 3
40002 40102
INPUTS 2
40001 40101
INPUTS 4
40003 40103
Line Input