Extron electronics DTP CrossPoint 84 - DSP SIS Commands; Command and Response Table for DSP SIS Commands

DTP CrossPoint 84 Series Matrix Switchers • HTML Operation 130
HTML Operation
The DTP CrossPoint Matrix Switcher can be remotely controlled via:
• SIS commands (see Programming Guide starting on page51)
• The Extron Product Configuration Software and DSP Configurator software (see Matrix
Software on page70)
• The built-in HMTL page (see below)
This section details using the built-in HTML page to perform a variety of tasks. Subjects
includes:
•
Download the Startup Page and View Switcher Status
• Change the Communications Settings
• Update the Firmwar
e
•
Set Passwor
ds
•
Set the Clock
The switcher can be monitor
ed and configured through its LAN port, connected via a
LAN or WAN, using a compatible web browser. The browser display has the appearance
of a web page. This chapter describes the factory-installed HTML page, which is always
available and cannot be erased or overwritten.
NOTES:
• For best results, Extron recommends the following browsers:
• Microsoft Internet Explorer, version 8.0 or newer, with compatibility mode off
• Mozilla Firefox, version 6 or newer
• Google Chrome, version 9 or newer
• Apple Safari, version 4 or newer
• If your Ethernet connection to the matrix switcher is unstable, try turning off the
proxy server in your Web browser. In Microsoft Internet Explorer, click Tools >
Internet Options > Connections > LAN Settings, uncheck the Use a proxy
server... box, and then click OK.