Extron electronics DTP CrossPoint 84 - Audio Input and Output Connections

DTP CrossPoint 84 Series Matrix Switchers • Installation 13
E
Output TP function switches, outputs 3 and 4 (see figure 2 on
XTP
DTP
HDBT
page 11) — These switches tailor the output signals for output 3 and 4 as
follows:
ATTENTION:
• Position this switch BEFORE connecting the appropriate device to
the TP connector. Failure to comply can damage the endpoint.
• Positionnez le sélecteur AVANT de connecter l’appareil approprié
au connecteur TP. Ne pas respecter cette procédure pourrait
endommager le point de connexion.
XTP position — If the receiving device is an XTP CrossPoint matrix switcher,
set these switches to the XTP position. The TP output is compatible with an
XTP CrossPoint matrix switcher and consists of HDMI with embedded audio plus
RS-232 and IR.
HDBT position — For HDBaseT-enabled receivers, set these switches to the HDBT
position. The TP output is compatible with HDBaseT-enabled devices and consist of
HDMI with embedded audio plus RS-232 and IR.
DTP position — If the connected receiving device is in the Extron DTP series, set these
switches to the DTP position. TP output is compatible with a DTP receiving device and
consists of HDMI with embedded audio, analog audio, RS-232 and IR, and remote
power.
F
TP Outputs 3 and 4 — Connect STP cables between these RJ-45
SIG LINK
OUT
connectors and compatible Extron DTP receivers or XTP matrix switchers
or HDBaseT-enabled devices (see TP connectors on page 17 to wire the
connector).
ATTENTION:
• Do not connect this port to a computer data or
telecommunications network.
• Ne connectez pas ces port à des données informatiques ou à un
réseau de télécommunications.
Audio Input and Output Connections
AMP OUTPUT
1
CLASS 2 WIRING
DTP CrossPoint 84 IPCP SA
DTP CrossPoint 84 IPCP MA
4
Tx Rx G
S/PDIF
OUT
EXP
+48V
MIC/LINE
1
1
3
2
4
2
3
4
LINK
REMOTE
AUDIO INPUTS
AUDIO OUTPUTS
DMP EXPANSION
1
LR
1
LR
3
LR
3
LR
5
LR
2
LR
4
LR
2
LR
4
LR
6
LR
RESET
1
L
R
4
CLASS 2 WIRING
8/
AMP OUTPUT
Figure 5. Audio Input and Output Connections and Indications
For inputs and outputs on captive screw connectors (
G
,
H
, and
J
) the
connectors are included with the switcher, but you must supply the audio cable.
G
Audio Inputs 1 through 6 — Connect balanced or unbalanced stereo
LR
audio inputs to these 5-pole, 3.5 mm captive screw connectors (see
Analog audio input connectors on page19 to wire the connectors).
H
Mic/Line Inputs 1 through 4 — Connect microphones or other mono
audio inputs to these 3-pole, 3.5 mm captive screw connectors (see
Mic/Line input connectors on page19 to wire the connectors).
I
+48 V (phantom power) LEDs — These LEDs light to indicate that +48 V
+48V
1
phantom power is applied to the associated mic/line inputs.
5
TP Outputs 3 and 4
Audio Inputs 1 through 6
Mic/Line Inputs 1 through 4
+48 V (phantom power) LEDs
Output TP function switches