DTP CrossPoint 84 Series Matrix Switchers • Installation 16
Detailed Pin Assignments, Wiring, and Sample Applications
HDMI connectors
Figure 8 defines the pinout for the HDMI protocol.
Pin Signal
1
TMDS data 2+
TMDS data 2-
TMDS data 0+
TMDS clock- +5 V power
Hot plug detect
CEC control
Reserved
(NC)
TMDS data 1+ TMDS clock+
TMDS clock
shield
SDA
DDC / CEC
Ground
TMDS data 2
shield
Pin Pin Signal Signal
2
713
41016
11 17
12 18
19
14
3
TMDS data 0-
TMDS data 0
shield
8
9
SCL
15
TMDS data 1-
TMDS data 1
shield
5
6
HDMI
HDMI
Type A Receptacle
Type A Plug
1
18 2
19
182
Pin Signal Pin Signal Pin Signal
1 TMDS data 2+ 8 TMDS data 0
shield 14 Reserved (NC)
2 TMDS data 2
shield 9 TMDS data 0- 15 SCL
3 TMDS data 2- 10 TMDS clock+ 16 SDA
4 TMDS data 1+ 11 TMDS clock shield 17 DDC/CEC Gr
ound
5 TMDS data 1
shield 12 TMDS clock- 18 +5 V power
6 TMDS data 1- 13 CEC contr
ol 19 Hot plug detect
7 TMDS data 0+
Figure 8.
HDMI Connector
Use the LockIt Lacing Brackets, supplied with the switcher
, to securely fasten HDMI cables
to devices as follows (see figure9):
1.
Plug the HDMI cable into the panel connection.
3
44
55
22
Figure 9. Installing the LockIt Lacing Bracket
2. Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it. The screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket.
ATTENTION:
• Do not overtighten the HDMI connector mounting screw. The shield to which it
fastens is very thin and can easily be stripped.
• Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket as shown.
5. While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length.
8
9
To Next Page
Loading...
