Extron electronics DTP CrossPoint 84 - Page 33

DTP CrossPoint 84 Series Matrix Switchers • Operation 25
C
ENTER button (see figure17 on page22) — The Enter button has two primary
functions () and two secondary functions (•):
 Saves configuration or other changes that you make on the front panel. To create a
simple configuration:
• Specify video, audio, or both (see Video button [
G
] and Audio button [
H
]
both on page26).
• Press the desired Input button (see Inputs buttons on page24,
A
).
• Press the desired Output button (see Outputs buttons on page24,
B
).
• Press the Enter button.
 Indicates that a potential tie or other change has been created but not saved.
• With the Preset, View, and Esc buttons, selects Serial Port Configuration mode.
• Selects 9600 baud for the rear panel Remote port in Serial Port Configuration mode
and indicates the selection.
D
Preset button — The Preset button has one primary function () and three
secondary functions (•):
 Activates Recall Preset mode to activate a previously-defined preset and indicates
the selection.
•
W
ith the Enter, View, and Esc buttons, selects Serial Port Configuration mode.
•
Selects 19200 baud for the r
ear panel Remote port in Serial Port Configuration
mode and indicates the selection.
•
W
ith the View and Esc buttons, selects front panel security Lock mode 2 or
toggles between mode 0 (unlocked) and mode 2.
E
View (
<
) button — The View (
<
) button has one primary function () and five
secondary functions (•):
 Select and indicate View-only mode, which displays the current configuration.
NOTE: View-only mode also provides a way to mute and unmute the outputs.
•
W
ith the Esc button, indicates Input Audio Configuration mode.
•
W
ith the Enter, Preset, and Esc buttons, selects Serial Port Configuration mode.
•
Selects 38400 baud for the r
ear panel Remote port in Serial Port Configuration
mode, and indicates the selection.
•
W
ith the Preset button and Esc button, selects between front panel locks
(Lock mode 2 and Lock mode 0).
•
W
ith the Esc button, selects between front panel locks (Lock mode 2 and
Lock mode 1).
Enter button
Preset button
View Button