RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
127
Using the K Panel Resin tab
Use this tab to adjust the Print All Black with K Panel (options), and the Defined Areas. Use
this tab to control where the resin black (K) panel of a full-color Ribbon is printed.
• Resin black text is desirable due to its sharp, saturated color, and resin black barcodes
are required to ensure readability when scanned by an infrared barcode reader. (Note:
The Printer driver will automatically print all TrueType black text and TrueType barcodes
only with the resin black (K) panel of the print Ribbon by default.)
• If printing black text or barcodes that are not TrueType fonts or black graphics, select one
of the three options listed under Print All Black with K Panel. See the Selecting the Full
Card with the K Panel Resin tab procedure on the next page. (Note: The Printer driver
will print areas of the image where it finds black coloring with the print Ribbon's resin
black (K) panel, as specified by each of the following options.)
To Next Page
