RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
55
Replacing the Headlift Sensor (A000126)
Tools Needed: Phillips-head Screwdriver, Torx T10 Screwdriver,
Step Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the
Printer.
2 Lift up on the bottom edge of the Top Lid (D850289); tilt it back into the fully
open position.
3 Use the Phillips-head Screwdriver to remove the two screws (130939) located
near the hinges.
4 Release the plastic tabs in the four corners of the cover.
5 a. Carefully lift the cover off of the Printer.
b. Remove the LCD interface cable at the main circuit board, and disconnect
the grounding cable at the power supply casing.
6 a. Completely remove the Card Output Hopper from the Printer by pulling back
the release tab at the bottom of the Printer.
b. Remove the two (2) Circuit Board mounting screws located in the Hopper
opening.
Continued on the next page
To Next Page
Loading...
