RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
183
Resolving the FPGA Error
Symptom: An unexpected hardware error has occurred.
Step Procedure
1 Reboot the Printer.
2 If the problem persists, the Main Board will need to be replaced. See the
Replacing the Main Board
procedure on page 29.
3 As an alternative to replacing the Main Print Board, the chip U2 (080066) can be
replaced. (Note: FARGO recommends that only a qualified electronics
technician perform this procedure.)
To Next Page
Loading...
