FARGO electronics DTC500 Series - Changing the BAUD Rate Settings; Adjusting the Flipper Offset

RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
205
Changing the BAUD Rate Settings
Apply this setting only if the Printer provides support for the Embedded Fonts and Bar Codes
option.
Step Procedure
1
Select MENU, Setup Printer, and BAUD Rate Settings.
2
Change to the appropriate option: 19200 or 9600.
3
Press the Select button to save the value.
Adjusting the Flipper Offset
Step Procedure
1
Select MENU, Setup Printer, and Flipper Offset.
2
Select Level or Encoder Angle.
• Use the Level option to set the position of the Flipper so it is level with the
card path.
• Use the Encoder Angle option to fine tune the position of the Flipper in
relation to the Printer's built-in Encoder if your Printer is equipped with this
option.
3 Change these settings in small increments if the card is not feeding correctly off
the Card Flipper onto the card path or into he Encoder.
• Decrease the Flipper Offset setting to lower the lip of the Flipper.
• Increase the setting to raise it.
4
Press the Select button to save the value.