FARGO electronics DTC500 Series - Showing the Card Count; Selecting the System Upgrade (Firmware Upgrade)

RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
207
Showing the Card Count
Step Procedure
1
Choose SHOW CARD COUNT to view counts for Card Count (CC) and Pass
Count (PC).
• Card Count is the total number of cards the Printer has produced.
• Pass Count is the total number of print passes made by the Printhead.
(Note: A pass is measured each time a single Ribbon panel is printed or
passes beneath the Printhead.)
Selecting the System Upgrade (Firmware Upgrade)
This option is used to upgrade the Printer Firmware.
Step Procedure
1
Upgrade by selecting SYSTEM UPGRADE.
The LCD will prompt: Are you sure you want to continue?
2
Select YES to begin the System Upgrade.
OR
Select NO to return to the READY screen. See the the Updating the Printer’s
Firmware procedure on page 209.