FARGO electronics DTC500 Series - Page 34

RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
34
DTC500 Board Cable Connections Reference (continued)
Description Location
Hopper Lift Motor and Hopper Transport Motor J24
RFID Antenna Coil J25
Main Stepper Motor J26
Flipper Table Angle Stepper J27
Unused, Spare Sensor Circuitry J29
Flipper Feed/Encoding Feed Stepper J30
Print TOF Sensor J31
Hopper Position Sensor J32
Unused, SCI Interface J33
P1 = Card Detection Sensor, P3 = Hopper Lift Sensor, P4 =
Hopper Transport Sensor
J4
P1 = Printhead Arm Sensor, P2 = Headlift Sensor, P3 = Ribbon
Encoder Sensor
J6
P1 = Flipper Home Sensor, P2 = Encoding TOF Sensor J7
Printhead: 12-Pin Connector J8
Printhead: 20-Pin Connector J9
Magnetics Board JP1
No Cable Assembly: Serial Port Connection P1