RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
116
Resolving the Card surface debris problems
Symptom: Prints have spots (white or colored voids) and/or dust on them, as shown after
Step 4 in this procedure.
Step Procedure
1 Be sure the cards are clean and stored in a dust-free environment.
Caution: Cards with embedded contaminants in the surface should
not be used.
2 Clean the inside of the Printer.
a. Open the Top Cover and Printhead Arm.
b. Remove the print Ribbon from the Printer.
c. Use a can of compressed air to blow out all visible areas of the Printer
interior.
d. Use a cleaning pad from the Printer Cleaning Kit to wipe out all visible areas
inside the Printer.
e. Remove any debris that may be inside.
Caution: Be extremely careful not to let any alcohol drip inside the
Printer!
f. Re-install the printing supplies.
g. Close the Top Cover and Printhead Arm.
To Next Page
Loading...
