RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
200
Using the Overlay/Print Area
Use these Overlay/Print Area options to control both the print and overlay together or
control each individually.
Step Procedure
1
Select For Print and Overlay for the defined area to apply to both the printing and
overlay process.
OR
Select For Overlay Only for the defined area to apply only to the overlay process.
(Note: In this mode, printing will still be allowed over the entire card and only the
overlay will be affected.)
OR
Select For Print Only (No Overlay) for the defined area to apply only to the print
process. (Note: In this mode, the overlay is completely disabled; so it will not be
applied.)
Caution: An overlay or an overlaminate must protect Dye-Sublimation
printing or it will quickly begin to wear or fade.
Continued on the next page
To Next Page
Loading...
