RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
233
Adjusting the Transfer Dwell Time and Transfer Temperature
Step Procedure
1 Adjust the Transfer Dwell Time and the Transfer Temperature to control the
Lamination Dwell Time or through-put speed of a card in seconds/inch and the
Lamination Temperature.
Selecting the Sensors button and Defaults button
Step Procedure
1
Select the Sensors button to bring up a separate dialog to calibrate the
Lamination Sensor. See the next page.
2
Adjust the Default settings as needed when using other types of cards. (Note:
The Default settings for the Lamination Dwell Time and Temperature are
preset for factory-recommended card stocks and overlaminate types.)
To Next Page
Loading...
