RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
22
Selecting Orientation - Portfolio under Card tab _________________________________________209
Selecting the Visual Security Solutions dropdown menu (E to H)____________________________210
Selecting the VeriMark radio button __________________________________________________211
Selecting the HoloMark radio button __________________________________________________212
Reviewing the Custom VeriMark Card ________________________________________________213
Reviewing the Custom HoloMark Card ________________________________________________214
Using SmartShield Area dropdown menu ______________________________________________215
Using the Card tab___________________________________________________________________216
Selecting the Card Size_____________________________________________________________217
Using the Card Hopper Selection (DTC515/DTC525 only) option ___________________________219
Reviewing the Orientation __________________________________________________________222
Specifying the Copies______________________________________________________________222
Using the Test Print button__________________________________________________________223
Clicking on the About button ________________________________________________________224
Using the Image Position button______________________________________________________225
Using the Lamination tab (only with Card Lamination Module) _______________________________228
Selecting the Lamination Position ____________________________________________________229
Selecting the Lamination Side _______________________________________________________230
Selecting the Lamination Type_______________________________________________________231
Selecting the Lamination Type_______________________________________________________232
Adjusting the Transfer Dwell Time and Transfer Temperature ______________________________233
Selecting the Sensors button and Defaults button_________________________________________233
Calibrating the Card Lamination Module’s Lamination Sensor______________________________234
Section 5: Cleaning___________________________________________________________ 235
Safety Messages (review carefully)______________________________________________________235
Cleaning the Printhead (850102) _____________________________________________________236
Replacing the Card Cleaning Tape____________________________________________________237
Cleaning the Platen and Card Feed Rollers _____________________________________________239
Cleaning the Platen________________________________________________________________242
Cleaning the Printer's Exterior _______________________________________________________243
Cleaning the Printer's Interior________________________________________________________243
Section 6 Packing the DTC500 Card Printer______________________________________ 245
Section 7 Board Level Diagnostics_______________________________________________ 246
Board Errors _______________________________________________________________________246
Resolving the EE Memory Error _____________________________________________________246
Resolving the EE Checksum Error____________________________________________________246
Resolving the DRAM Memory Error__________________________________________________247
Resolving the RAM Memory Error ___________________________________________________247
Resolving the FPGA Error __________________________________________________________247
Sensor Testing______________________________________________________________________248
Reviewing the Sensor Location and Voltages ___________________________________________249
Reviewing the Sensor Layout on Ribbon Sensor array ____________________________________250
Section 8 LCD On-Line Menu Navigation________________________________________ 251
Entering the LCD Menu and selecting an Option ___________________________________________251
Using the Softkey and Scroll buttons __________________________________________________252
Accessing the Menu Option Structure Tree________________________________________________252
Selecting from the Menu Option Structure Tree__________________________________________253
Using the LCD Menu ________________________________________________________________254
Printing the Self-test_______________________________________________________________254
Reviewing the Gray/Align YMC (DTC510/515) and Gray/Align YMC/K (DTC520/525) Self-Test _255
Reviewing the Color/Resin YMCK Self-Test ___________________________________________255
Reviewing the Card Count YMC Self-Test _____________________________________________256
Reviewing the Standard Resin Self-Test _______________________________________________256
To Next Page
Loading...
