1 Safety and requirements for product use
Festo – GDCP-CMMS/D-FW-EN – 1404NH – Engli sh 15
1.2 Requirements for product use
• Make this documentation available to the design engineer, installer and personnel responsible for
commissioning the mach ine or system in which this product is used.
• Make sure that the specifications of the documentation are always complied with. Also consider the
documentation for the other components and modules.
• Take into consideration the legal regulations applicable for the destination as well as:
– Regulations and standards,
– R egulations of the testing organisations and insurers,
– National specifications.
1.2.1 Transport and storage conditions
• Protect the product during transport and storage from impermissible burdens, such as:
– Mechanical loads
– Impermissible temperatures
– Moisture
– Aggressive atmosphere
• Store and transport the pro duct in its original packaging. The original packaging offers suf ficient
protection from typical stresses.
1.2.2 Technic al requirements
For correct and safe use of the product:
• Comply with the c onnect io n and ambient conditions of the product specified in the technical data
“Mounting and installation” description, GDCP-CMMS-AS-G2-HW-…/GDCP-CMMD-AS-HW-…/
GDCP-CMMS-ST-G2-HW-…, Appendix A.1, and of all connected components. Compliance with the
limit values and load limits permits operation of the product in compliance with the relevant safety
regulations.
• Observe the instructions and warnings in this documentation.
1.2.3 Qualification of trained per sonnel
The product may only be placed in operation by a qualified electrotechnician who is familiar with:
– Installation and operation of electrical control systems,
– The applicable regulations for operating safety-engineered systems,
– The applicable regulations for accident protection and operational reliability, and
– The documentation for the product.
1.2.4 Range of application and certifications
The motor controller with integrated STO safety function is a safety-related part of the control systems.
The motor c ontroller carries the CE marking; for standards and test values
“Mounting and installation” description, GDCP-CMMS-AS-G2-HW-…/GDCP-CMMD-AS-HW-…/
GDCP-CMMS-ST-G2-HW-…, Appendix A.1.
The product-relevant EU directives can be found in the declaration of conformity.
Certificates and the declaration of c onformity for this product www.festo.com/sp
To Next Page
Loading...
Need help?
General
