Festo CMMS-AS Series User Manual

CMMS-AS/CMMS-ST/CMM D -AS
Festo – GDCP-CMMS/D-FW-EN – 1404NH – Engli sh 243
Index
A
Address of the fieldbus 83..................
Analogue interface 66......................
– Analogue input signal 66..................
– Analogue input/output 66.................
– Analogue output signal 67................
Analogue monitor 203......................
Analogue setpoint value specification 66.......
C
Certificates 16............................
CiA 402 75...............................
Commutation finding 103...................
Control interfaces 47.......................
D
Data interfaces 86.........................
Data rate 84.............................
Declaration of c onformity 16................
Device data (FCT) 90.......................
Device profiles
– CANopen device profile CiA 402 75..........
– Festo Handling and Positioning
Profile (FHPP) 75........................
Digital interfaces 50.......................
– Digital I/O modules 50...................
– Digital input signals 53...................
– Digital output signals 57..................
DI L switches 82...........................
Dimension reference system 76..............
– linear drives 76.........................
–rotativedrives 77........................
E
Enc oder emulation 199.....................
Encoder interfaces
– Enc oder input 68........................
– Enc oder output 69.......................
– Forward/reverse signals 72................
CW/#CW/CCW/#CCW 72..................
– Incremental signals 70...................
A/#A/B/#B/N/#N 70.....................
– Pulse/direction signals 71.................
CLK/#CLK/DIR/#DIR 71...................
Endless positioning 206....................
Error message 214........................
F
FCT 79..................................
Festo Configuration Tool ( FCT) 79.............
FHPP 75.................................
Fieldbus interfaces 73......................
–CANOpen 73...........................
– DeviceNet 73...........................
–DriveBus 73............................
–PROFIBUSDP 73........................
– RS485 73..............................
Firmware file 87...........................
Firmware file (.S) 88
.......................
Flying measurement 201....................
H
Holding brake 106.........................
Homing 155..............................
I
I2t monitoring 211.........................
Intended use 14..........................
Interruption and failure monitoring 210........
L
LED indicators
– Bus 213...............................
– CAN 213...............................
– Ready 213.............................
Limit switches 78.........................

Festo CMMS-AS Series Specifications

General

Brand	Festo
Model	CMMS-AS Series
Category	Controller
Language	English