Fike FCP-300 - Page 84

84 FCP-300/FCP-300ECS Manual — P/N LS10145-002FK-E:A 3/12/2021
Programming Overview Programming Menu Quick Reference
Zone
Edit Zone Select Zone
Edit Zone Name
See “Edit Zone Name”
on page 122.
Zone
Properties
Verification Type
*1-Count
See “Edit Zone
Properties” on page 122.
2-Count
Alarm Ver.
PAS
SNGL ILOCK
DBL ILOCK
Heat Temp Set
135° to 150°F
SD devices
See “Edit Zone
Properties” on page 122.
135° to 190°F
FIK or SK device See
“Edit Zone Properties”
on page 122.
Smoke
Sensitivity
Low
See “Edit Zone
Properties” on page 122.
Medium
High
Zone
Accessory Opt
Single/Multi-
station Cadence
00-23
See “Zone Accessory
Options” on page 124.
CO Single/Multi
station Cadence
00-23
Local Zone
Yes
No
View Zone Points Select Zone Section 9.4.2
Group
Edit Group Select Group
Group Name
See “Edit Group Name”
on page 124.
Section
Group
Properties
Voice Group Y or N
Switch 1-64
Template
Override
Y or N
Allow Sys
Override
Y or N
Dynamic
Act/Template
Override
Cadence
00-23 (See Appendix C)
View Group Points Select Group Section 9.4.2
Edit OPG Template Select template Modify name and which OPGs are in template Section 9.4.3
Menu Options/Defaults Comments
Table 8.4 Programming Quick Reference Chart (Continued)