E-Label, regulatory information
102 MMS
®
Inspection DPM High
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this device does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user‘s authority to operate the equipment!
Information about Specific Absorption Rate (SAR)
This device is designed and manufactured not to exceed the emission limits for ex-
posure to radio frequency (RF) energy set by the Federal Communications Commis-
sion of the United States.
During SAR testing, this device was set to transmit at its highest certified power lev-
el in all tested frequency bands, and placed in positions that simulate RF exposure
in usage near the body. Although the SAR is determined at the highest certified
power level, the actual SAR level of the device while operating can be well below
the maximum value. This is because the Device is designed to operate at multiple
power levels so as to use only the power required to reach the network.
The exposure standard for wireless devices employing a unit of measurement is
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6 W/kg.
The FCC has granted an Equipment Authorization for this model Device with all re-
ported SAR levels evaluated as in compliance with the FCC RF exposure guidelines.
SAR information on this model Device is on file with the FCC and can be found under
the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID:
2ATFE-MMSINSPEC00.
For this device, the highest reported SAR value for near the body is 0.001134 W/kg.
While there may be differences between the SAR levels of various devices and at
various positions, they all meet the government requirements.
To Next Page
Loading...
