Data transfer
55
MMS
®
Inspection DPM High
8.5 Bluetooth data transfer to a CAQ system
Information on how to use your CAQ program can be found in the corre-
sponding Operator's Manual (
CAQ program).
Information on how to use your Bluetooth program on your CAQ system
can be found in the corresponding Operator's Manual (
Bluetooth pro-
gram).
8.5.1 Data transmission formats
Output format: ASCII strings followed by a CRLF (Carriage Return Line Feed; CR
= ASCII13, LF = ASCII10)
8.5.2 Bluetooth-gage pairing
For data transfer via Bluetooth settings of the corresponding transfer parame-
ters in the CAQ system and in the gage are necessary.
Before you start
The CAQ system is available on the PC.
The PC contains a Bluetooth module/port.
The batteries in the gage have sufficient charging capacity.
We recommend replacing the batteries when the battery status dis-
plays are as follows: or . If the battery charge capacity is
too low, you will not be able to perform data transfer settings for
Bluetooth in the gage and data export via Bluetooth.
The desired parameters for the Bluetooth pairing are set in the gage; see
page 58.
Procedure
1. Settings in the gage.
Navigation
: Selects – parameter/value
: Confirms – selection/setting
:Exits – page/menu
To Next Page
Loading...
