Data transfer
56 MMS
®
Inspection DPM High
a Activate the data export via Bluetooth:
Main menu ( ) > Gage Settings > OK > Data Transfer > OK > PcDatex
> OK > Bluetooth Classic > OK > Block Separator> OK > PC-DATEX >
OK > Start Pairing > OK.
Parameter is activated:
Bluetooth connection PC – gage is coupled:
b Go to the Measurement view: 3 x > .
2. Establish the Bluetooth device pairing between your PC and the gage (MMS
Inspection)
► Open your Bluetooth program/App and add the MMS inspection gage
as a new gage or refresh the connection (
Bluetooth program/App
on the PC).
3. Settings in the CAQ system
a Register the gage in your CAQ program or connect it to your CAQ
program (
CAQ program).
b If necessary, adapt your transfer program. The output formats of the
measuring device can be found at the beginning of this chapter on
page 55.
The connection settings are finished.
What you can do next
Transfer data, see page 52.
To Next Page
Loading...
