FISCHER MMS - Description; Measurement View (Example)

Description
4 MMS
®
Inspection DPM High
2Description
The gage model MMS Inspection DPM
is for continuously measuring air
temperature and humidity to deter-
mine the dew point. To measure the
surface temperature continuously,
you can connect a magnetic tempera-
ture probe to the gage.
This operator's manual describes the
following gage version in the MMS In-
spection DPM series:
 High variant
USB and Bluetooth interfaces,
data storage for 250 000 values
in up to 2500 batches. You can
log the climate values over a
prolonged period and emit a vi-
sual warning if specified limits
are exceeded.
Additional information can be found in
the data sheet, page 9
2.1 Measurement view
(example)
1Batch name
2 Permanently measured and
calculated climatic values with
measurement units
3 Number of storages of all
climatic values
4 Key assignment line (example:
symbol for delete function,
symbol for calling the run
charts and statistics of all
climatic variables, symbol for
Hold function)
5 Status display; icons indicate,
e.g., active autom. gage switch-
off (clock), battery charge
status or the active connection
of Bluetooth or USB
6 Information area; A: alarm
function for the variable is
active; : trend display
A list of all display symbols and texts
can be found starting on page 90.
1
2
3
4
Batch 003
RH 34.9 %A
Ta
26.1 °C
Ts
27.2 °C
Td
10.3 °C
Ts-Td
16.9 °C A
n = 3
Example of the measurement
view with trend display ( )
and active alarm function (A)
/
5
6
/