FISCHER MMS - Default Setting - Unit of Measurement

Gage settings
75
MMS
®
Inspection DPM High
10.8 Default setting – unit of measurement
You can set the unit of measurement for temperature in which measurements
will usually be taken. All newly created batches are automatically assigned this
preset unit of measurement (Default Unit).
Navigation
: Selects – parameter/value
: Confirms – selection/setting
:Exits – page/menu
To set the default unit of measurement
► Main menu ( ) > Gage Settings > OK > More Settings > OK > Default
Unit > OK > select desired unit of measurement > OK
Parameter is activated:
The setting is finished.
What you can do next
 Go to the Measurement view: 2x > , measure, see page 28.
 Make further gage settings: > OK or 1x .
 Go to the main menu: 2x .
OK