FISCHER MMS - Test Measurements

Service
79
MMS
®
Inspection DPM High
11.3 Test measurements
For problem analysis, it can be helpful to perform test measurements. Our ex-
perts can use the climatic values shown in the display to draw conclusions
about the status of the sensors, for example, and propose potential solutions.
Test measurements and values displayed in a service sector, and this does not
affect the batches created in the gage.
Navigation
: Selects – parameter/value
: Confirms – selection/setting
: Exits – page/menu
To display the probe count rates
1. Open the service sector: Main menu ( ) > Gage Settings > OK > Probe
Settings > OK > Probe Raw Values > OK > Test DPM
2. Start the test measurement: OK
To stop the test measurement:
What you can do next
 Go to the Measurement view: 4x > , measure see page 28.
 Make further gage settings: 3x .
OK