Fluke 5320A - Page 195

Index (continued)
3
RS-232 port setup, 5-4
SCPI Command summary, 5-8
SCPI Commands, 5-7
Service Request Register, 5-45
Source commands, 5-17
Status Byte Register, 5-44
Status subsystem, 5-40
Syntax Information, 5-6
System commands, 5-39
Terminators, 5-7
Residual Impedance Correction
Sanning for, 4-15
Selecting of, 4-13
Setting of, 4-14
RS-232
Connector pinout, 5-5
Exceptions for remote control, 5-5
port setup, 5-4
Rules
of operation, 2-7
—S—
Safety, 1-5
General summary, 1-5
symbols, 1-7
SCPI
Abbreviations, description of, 5-8
Command summary, 5-8
Output commands, 5-17
Source commands, 5-17
Status commands, 5-40
System commands, 5-39
SCPI Commands, 5-7
Serial number
display of, 3-14
Service Request Enable Register, 5-45
Setup
Menu, 3-12
Sotware version
display of, 3-14
Spanish help guide, 3-10
Status Byte Registers, 5-44
Substitute Leakage Current
Calibration for, 4-20
Syntax
Information, 5-6
Rules, 5-6
—T—
Time
Setting system, 3-13
—U—
Unpacking calibrator, 2-3
—V—
Verification
Calibrator performance, 6-6
—W—
Warm-up, 2-7