Preparing the Calibrator for Operation
Installing the Calibrator in an Equipment Rack 2
2-5
Table 2-2. Line Power Cord Types Available from Fluke
Type Voltage Fluke Part No.
North America/Japan 120 V 2743310
Universal Euro 240 V 2743331
United Kingdom 240 V 2743322
Australia/China 240 V 2743346
South Africa/India 240 V 2743354
North America/Japan
Universal Euro
United Kingdom
Australia/China
SouthAfrica
ehq050.eps
Figure 2-1. Line Power Cord Types Available from Fluke
Selecting the Line Voltage
The Calibrator will operate on two different input line voltages. The present line voltage
setting is indicated on the outside of the line voltage switch found on the Calibrator’s rear
panel.
To change the line voltage:
1. Disconnect the Calibrator from line power by unplugging the line power cord.
2. Using a flat-blade screwdriver, rotate the switch until the desired voltage is under the
arrowhead on the line voltage switch.
3. Attach the Calibrator to the power source using a line power cord that will mate with
power source outlet.
Replacing the Fuses
The Calibrator uses fuses to protect both the line power input and measurement inputs.
Refer to the Operators Maintenance section of this manual for instructions on replacing
the Calibrator’s fuses.
Installing the Calibrator in an Equipment Rack
The Calibrator can be mounted in a standard-width, 24-inch (61-cm) deep equipment
rack. To mount the calibrator in an equipment rack, use the Rack Mount Kit, Model
Y5320A, instructions are included with the kit. For convenience, the rack mount
instruction sheet can be stored in the supplied binder of this manual.
To Next Page
Loading...
Need help?
General
